Protect the luminaire before trimming to prevent ash from entering the luminaire
Repair floor
Some low places use the floor carton pad
Floorboard baseboard accessories needed
Holding a floor for each door line
Master follows cutting
Do small wooden pillow
Punching holes in the ground
Master Wang is punching in front of Zhang Fei
Spread the damp-proof film
Photo of glue on the end of the floor
Cologne flooring is glued, but it is only used on the narrow side of the floor. The long side is not used! Therefore, the glue is rarely used, and after the glue is completely dried, the glue will change from white to transparent!
Master Wang helped put a few floor shapes to make even
Floor knowledge:
One-half to the seam: good-looking merchants have a great loss!
One-third of the seam: more optimistic about the loss less!
Quarter stitches: Not too good Look good!
Finally, I chose one-third of the compromise
The floor shop takes two days. The next day, Master Wang asked whether the floor should be floor-to-sew in the hall, if it were to be on the floor, and if the seam is torn, it would cause a relatively large loss! In order to tell him very firmly for the silver child, forget it. . .
Flooring Tips: Pairs of seams
Floors in the same area require seams
Because the tolerance of the floor is silk, it is one hundred millimeters of error. Therefore, as long as the cutting is done carefully, this can basically be done.
Do floors in different areas need seams? This depends on the silver in your pocket.
This method of seaming will increase the loss of the floor!
There are also areas where the floor is vertical.
After the two masters finished laying all the floors, they started nailing the baseboard.
Master Wang starts to make doorway and right angle buckles
First put a nail under the door strip, then press the nail against the position of the wooden pillow a little, let the nail stick into the wooden pillow, then use the hoe to knock the door buckle down!
Let's take a look at the achievements of the two masters!
Flooring